Electrokinetics of Natural and Mechanically Modified Ripidolite and Beidellite Clays

• Published in: Journal of colloid and interface science Vol. 181; no. 2; pp. 463 - 469
• Main Authors: Sondi, Ivan, Pravdić, Velimir
• Format: Journal Article
• Language: English
• Published: Elsevier Inc 10.08.1996
• Subjects: beidellite; clay minerals; electrokinetic potential; fulvic acid; milling; modification of surfaces; ripidolite; modification of surfaces; fulvic acid; ripidolite; beidellite; clay minerals; milling; electrokinetic potential
• ISSN: 0021-9797; 1095-7103
• DOI: 10.1006/jcis.1996.0403

Particles of clay minerals were studied due to their importance in geochemical processes in natural waters, such as adsorption and transfer of ionic contaminants, stabilization by organics, and flocculation and sedimentation phenomena. Information on the behavior of clays was sought by experiments with model systems. Measurements of electrophoretic mobilities in relation to pH, at varying concentrations of well-characterized fulvic acid (FA), were performed on two structurally well defined, representative clay minerals prepared with clean surfaces: ripidolite (a well-known trioctahedral nonswelling chlorite) and beidellite (a typical dioctahedral smectite). Natural ripidolite and beidellite show high negative electrokinetic potentials in the range pH 2 (−10 and −20 mV, respectively) to pH 10 (−60 and −50 mV, respectively). Experiments utilizing mechanical particle disintegration (dry milling), mimicking natural wear and physical weathering, resulted in increases of specific surface area (12.3 and 1.5 times, respectively) and of cation exchange capacity (3.2 and 1.2 times, respectively). Such small-sized particles, shown by SEM figures, retain their crystal structure (X ray) and the nature of their structural bonds (FTIR), exhibiting an IEP (at pH 6.0 and 3.0, respectively). This was interpreted to be the creation of positively charged edge surfaces. Exposed to fulvic acid in solutions of 10 −3NaCl at pH = 6.5, these new surfaces showed an increase in negative ζ-potential for ripidolite, and, to a smaller extent, for beidellite. In the interaction of clay mineral particles with aqueous medium, it is concluded that the degree of mechanical wear is more decisive than the type of the mineral.