Combustion of Iron Particles Suspension in Laminar Premixed and Diffusion Flames

• Published in: Combustion science and technology Vol. 194; no. 7; pp. 1356 - 1377
• Main Authors: Poletaev, N.I., Khlebnikova, M.Y.
• Format: Journal Article
• Language: English
• Published: Taylor & Francis 19.05.2022
• Subjects: diffusion dust flame; dispersed composition combustion products; Iron particles combustion mode; premixed dust flame
• ISSN: 0010-2202; 1563-521X
• DOI: 10.1080/00102202.2020.1812588

In the work, the combustion regimes of iron particles (d 10  = 4.7 µm) in a laminar pre-mixed flame (LPF) and in an axisymmetric laminar diffusion flame (LDF) are studied. For (LPF), we studied the effect of variations in gas suspension of the concentrations of fuel C f  = 0.4 ÷ 0.6 kg/m 3 and oxygen C O2  = 21 ÷ 40%, and for (LDF), pure oxygen blowing and variation in the iron concentration C f  = 0.4 ÷ 1.5 kg/m 3 . The results of particle temperature measurements in the combustion zone of LPF and LDF, the dispersed and phase composition of the combustion products (depending on the concentration of fuel and oxidizer) are presented. It is shown that, under certain conditions, iron particles in LPF switch to a "high-temperature" diffusion mode of combustion. This mode is accompanied by intensification of gas-phase reactions and leads to a two-mode particle size distribution of combustion products. In this mode of combustion of a gas suspension (at temperatures much lower than the boiling point of iron), the mass yield of a nanoscale fraction of combustion products reaches tens of percent and increases with increasing oxygen concentration in LPF. This mode of iron particles combustion was not observed in LDF. The features of the thermal structure of the diffusion dust flame are analyzed. It is shown that in LDF the burning time of metal particles in the diffusion mode is proportional to the particle radius ( in the kinetic mode), and should depend on the concentration of fuel and the size of the burner.