Scrape off layer modelling studies for SST-I

• Published in: Journal of nuclear materials Vol. 266; pp. 726 - 731
• Main Authors: Warrier, M., Jaishankar, S., Deshpande, S., Coster, D., Schneider, R., Chaturvedi, S., Srinivasan, R., Braams, B.J.
• Format: Journal Article
• Language: English
• Published: Elsevier B.V 01.03.1999
• Subjects: B2/EIRENE; Edge modelling; Erosion of graphite; B2/EIRENE; Erosion of graphite; T01; Edge modelling; P06
• ISSN: 0022-3115; 1873-4820
• DOI: 10.1016/S0022-3115(98)00816-2

SOL modelling results for SST-1 (SST Team, Proceedings of the 16th IEEE/NPSS Symposium on Fusion Engineering, Champaign, IL, vol. II, 1995, p. 481) show a sheath limited flow regime. This is due to the low edge densities required by lower hybrid current drive (LHCD), coupled with high power input per unit volume. Coupled plasma–neutral transport studies using B2-Eirene [R. Schneider et al., J. Nucl. Mater. 196–198 (1992) 810] show significantly high charge exchange losses and radiated power from the core. It also shows that the heat flux to the inner divertor is higher than that to the outer divertor due to thinner inner SOL widths. The Monte-Carlo neutral transport code DEGAS [D. Heifitz et al., J. Comput. Phys. 46 (1982) 309] was used to optimise the baffle plate geometry and it was seen that a configuration where the baffle plate shields the main plasma from the divertor strike point results in reduced backflow of neutrals. The divertor erosion code DIVER (M. Warrier et al., SST Divertor Modelling Report, 1996–1997) was used to predict a steady state operating temperature for the SST divertor plate lying in the range 750–1000°C for which the erosion will be minimum.