Pellet compliance model based on out-of-pile simulation

• Published in: Nuclear engineering and design Vol. 56; no. 1; pp. 117 - 122
• Main Authors: Ito, K., Wakashima, Y., Oguma, M.
• Format: Journal Article
• Language: English
• Published: Elsevier B.V 01.01.1980
• ISSN: 0029-5493; 1872-759X
• DOI: 10.1016/0029-5493(80)90175-2

The thermal and mechanical behavior of fuel rods is significantly influenced by the extent of their relocation and by compliance of the cracked pellets. Movement of the cracked pellet pieces towards the cladding results in softer pellets with crack voids which accommodate some fraction of the thermoelastic pellet deformation and make the pellet more compliant under the restraint of the cladding. It is difficult to model such a pellet compliance independently of experimental observations because the cracked pellet behavior is uncertain by nature. Electrically heated simulation of pellet-cladding mechanical interaction (PCMI) facilitates much quicker and more flexible experimentation than actual in-pile tests. Testing apparatus consists of the simulated fuel rod with hollow UO 2 pellets and a tungsten rod in the center, and a diameter measuring device including three pairs of diameter sensors. Test parameters include the pellet-cladding gap and the cladding thickness. Results show that rods with a smaller gap have a larger increasing rate of cladding diameter. This suggests that a group of cracked pellet pieces induced by thermal stress has an apparent compliance which increases with pellet-cladding gap. Results also show more sensitivity to cladding thickness than those calculated assuming pellets having intrinsic stiffness. This also suggests the compliant nature of cracked pellets. Such a compliant nature can almost be described by reducing the elasticity of the pellet. A simple pellet compliance model was obtained by fitting calculations with measurements to describe a cracked pellet as a uniform axisymmetric body with apparent elasticity.