Plasma Arc Welding of 780CP High Strength Steel Sheet Lap Joint for Tensile Strength of 100% Compared to Base Metal

• Published in: International journal of precision engineering and manufacturing Vol. 25; no. 5; pp. 925 - 931
• Main Authors: Han, Sang-Woo, Shin, Seungcheol, Kim, Hansol, Lee, Geonho, Jeon, Jongho, Han, Sangjun, Bae, Gyuyeol, Cho, Jungho
• Format: Journal Article
• Language: English
• Published: Seoul Korean Society for Precision Engineering 01.05.2024; Springer Nature B.V
• Subjects: Base metal; Beads; Engineering; Fillet welding; Fractures; Heat affected zone; High strength steel; High strength steels; Industrial and Production Engineering; Lap joints; Materials Science; Metal sheets; Plasma arc welding; Plasma jets; Regular Paper; Tensile strength; Weaving; Welding current; Welding parameters; Welding wire; Lap joint; Plasma arc welding (PAW); PAW with welding wire; Tensile strength; High strength steel
• ISSN: 2234-7593; 2005-4602
• DOI: 10.1007/s12541-024-00957-1

Homogeneous and heterogeneous PAW (plasma arc welding) experiments were conducted to obtain weld beads with tensile strength of 100% or more compared to that of the base metal in lap joint fillet welding of CP (complex phase) 780 MPa grade high strength steel sheet. Homogeneous and heterogeneous welding mean welding technic without and with welding wire in each. Common basic welding parameters of both homogeneous and heterogeneous PAW wire were applied, including welding speed of 21 cm/min, arc length of 3.5 mm, weaving amplitude of 3 mm, work angle of 30°, and Ar 99.99% shielding gas with 12 L/min. In homogeneous PAW, the optimized additional welding conditions were a welding current of 90 and 95 A, push angle of 20°, and weaving frequency of 5 Hz. The fracture strengths of all the samples were less than that of the base metal, and all fractures occurred at the weld bead fusion zone due to insufficient reinforcement. In heterogeneous PAW, the optimized additional welding conditions were a welding current of 125 A, push angle of 0°, weaving frequency of 4 Hz, and wire feed speeds of 1.53 and 1.38 m/min. Moreover, the welding wire was fed from behind the arc. The fracture strengths of all the samples were greater than that of the base metal, and fractures occurred at the base metal or fusion zone boundary. The reason for higher tensile in heterogeneous PAW wire is deduced as the large cross-section area of reinforcement provided by the welding wire comparing to homogeneous welding. It is well known that small radius of welding heat source clearly produces narrow heat affected zone. Therefore, the PAW produces relatively narrower heat affected zone, then resulted as fully enough strength of weldment. This is another reason of the current achievement.