Effect of surface treatment by ceramic conversion on the fretting behavior of NiTi shape memory alloy

• Published in: Tribology letters Vol. 25; no. 3; pp. 215 - 224
• Main Authors: Yang, Hui, Qian, Linmao, Zhou, Zhongrong, Ju, Xinhua, Dong, Hanshan
• Format: Journal Article
• Language: English
• Published: Dordrecht Springer Nature B.V 01.03.2007
• Subjects: Accommodation; Bonding strength; Conversion; Fretting; High temperature; Intermetallic compounds; Martensite; Martensitic transformations; Nickel base alloys; Nickel titanides; Shape memory alloys; Slip; Spallation; Substrates; Surface layers; Surface treatment; Titanium dioxide; Tribology; Wear mechanisms; Wear resistance
• ISSN: 1023-8883; 1573-2711
• DOI: 10.1007/s11249-006-9169-6

Three types of surface-treated NiTi samples, M-1 (700 °C/0.5 h), M-2 (650 °C/1 h) and M-3 (400 °C/50 h), were prepared by ceramic conversion treatment under different conditions. The effect of the surface treatment on the fretting behavior of NiTi alloy was investigated in the Ringer’s solution by using a horizontal servo-hydraulic fretting apparatus. The experimental results indicated that the surface layer of the low temperature (400 °C) treated samples M-3 was dominated by a single TiO2 layer, while the high temperature (650 and 700 °C) treated samples M-1 and M-2 consisted of surface TiO2 layer followed by a TiNi3 layer. These surface layers were found to have a strong effect on the fretting behavior of the NiTi alloy in terms of changes in the shape of the curves of the tangential force (Ft) versus displacement (d), the fretting regimes and the damage mechanisms involved. The stress-induced reorientation of martensite bands in the NiTi alloy could decrease the slope of the Ft–d curve and thus increase the elastic accommodation ability of the NiTi plate against 1Cr13 steel ball pair. However, since the surface-treated layers could suppress the martensite reorientation in the NiTi substrate and thus decrease the elastic accommodation ability of NiTi, the gross slip started at a smaller displacement amplitude for the surface-treated NiTi samples than for the untreated one. The main wear mechanism of the as-received NiTi alloy in slip regime was adhesion and delamination, while the major damage to the high temperature treated NiTi samples M-1 and M-2 was determined as the spallation of surface-treated layers. Due to the high bonding strength of the surface-treated layer with NiTi substrate, the low temperature treated NiTi samples M-3 showed the best fretting wear resistance in all samples tested.