Wear analysis of Cu–Al coating on Ti–6Al–4V substrate under fretting condition

• Published in: Tribology letters Vol. 19; no. 3; pp. 239 - 248
• Main Authors: Lee, H., Mall, S., Sanders, J.H., Sharma, S.K.
• Format: Journal Article
• Language: English
• Published: Dordrecht Springer Nature B.V 01.07.2005
• Subjects: Abrasive wear; Abrasives; Aluminum coatings; Copper; Displacement; Fretting; Materials fatigue; Slip; Substrate inhibition; Thickness; Titanium base alloys; Tribology
• ISSN: 1023-8883; 1573-2711
• DOI: 10.1007/s11249-005-6151-7

Fretting behavior of Cu–Al coating on Ti–6Al–4V substrate was investigated with and without fatigue load. Soft and rough Cu–Al coating resulted in abrasive wear and a large amount of debris remained at the contact surface, which caused an increase in tangential force during the fretting test under gross slip condition. Fretting in the partial slip condition also showed the wear of coating. To characterize wear, dissipated energies during fretting were calculated from fretting loops and wear volumes were obtained from worn surface profiles. Energy approach of wear analysis showed a linear relationship between wear volume and accumulated dissipated energy. This relationship was independent of fatigue loading condition and extended from partial slip to gross slip regimes. As an alternate but simple approach for wear analysis, accumulated relative displacement range was correlated with the wear volume. This also resulted in a linear relationship as in the case of accumulated dissipated energy suggesting that the accumulated relative displacement range can be used as an alternative parameter for dissipated energy to characterize the wear. When the maximum wear depth was equal to the thickness of Cu–Al coating, harder Ti–6Al–4V substrate inhibited further increase in wear depth. Only when a considerable energy was supplied through a large value of the applied displacement, wear in the substrate material could occur beyond the thickness of coating.