The Precipitation Behavior of γ′ Phase in Single Crystal Ni-Based DD6 Superalloy for Turbine Blade

• Published in: Materials science forum Vol. 898; pp. 534 - 544
• Main Authors: Li, Jia Rong, Xiong, J.C., Xue, Yan Peng, Zhao, Jin Qian
• Format: Journal Article
• Language: English
• Published: Pfaffikon Trans Tech Publications Ltd 19.06.2017
• Subjects: Alloys; Chemical precipitation; Cooling rate; Crystals; Diffusion rate; Directional solidification; Eutectic temperature; Forming; Nickel base alloys; Normal distribution; Nucleation; Phase transitions; Position measurement; Precipitates; Segregations; Single crystals; Directional Solidification; DD6; γ′ Precipitation; Nickel-Based Superalloy
• ISSN: 0255-5476; 1662-9752; 1662-9752
• DOI: 10.4028/www.scientific.net/MSF.898.534

The precipitation behavior of γ′ precipitates in typical section dimensions of DD6 single crystal superalloy turbine blade was investigated experimentally during directional solidification process. The phase transformation temperatures in the single crystal Ni-based DD6 superalloy from DSC analysis and JmatPro simulation were basically in consistent with the isothermal solidification experiments. The solidification route of DD6 single crystal superalloy could be described as follows: L1 → γ + L2; L2 → (γ + γ′)eutectic + MC; γ → γ′/γ. With increasing continuous cooling rates, the primary γ′ precipitates tended to be refined, and the size distributions of the primary γ′ precipitates at every temperature measuring position followed the normal distribution. In comparison to the interdendritic regions, nearly a 60% reduction in the average sizes of the primary γ′ precipitates was measured in the dendritic core regions. The result of the primary γ′ size difference was strongly affected by the multi-component segregations between the interdendritic and dendritic regions, where the γ′ forming elements of Al and Ta segregated towards the interdendritic regions. Furthermore, the secondary γ′ precipitation was found to occur within a relatively wide corridor of γ matrix for low cooling rates (12.6, 23.3 and 29.7 °C/min) during the directional solidification process. The occurrence of the secondary γ′ precipitation resulted from the complex interaction of multiple thermodynamic and kinetic factors in the γ′ nucleation and the diffusion rate of γ′ forming elements.