Effects of Ag Flake Addition in Sn-3.0Ag-0.5Cu on Microstructure and Mechanical Properties with High-Temperature Storage Test

• Published in: Journal of electronic materials Vol. 50; no. 10; pp. 5639 - 5646
• Main Authors: Jang, Jun-Ho, Min, Kyung Deuk, Lee, Choong-Jae, Hwang, Byeong-Uk, Jung, Seung-Boo
• Format: Journal Article
• Language: English
• Published: New York Springer US 01.10.2021; Springer Nature B.V
• Subjects: Bonded joints; Bonding strength; Characterization and Evaluation of Materials; Chemistry and Materials Science; Copper; Electronics and Microelectronics; Flakes; High temperature; Instrumentation; Integrated circuits; Intermetallic compounds; Liquid phase sintering; Liquid phases; Materials Science; Mechanical properties; Melting; Microstructure; Optical and Electronic Materials; Original Research Article; Shear tests; Silver; Sintering (powder metallurgy); Soldered joints; Solders; Solid State Physics; Stacking; Thermodynamic properties; Tin; Tin base alloys; 3D integrated circuit packaging; high-temperature storage test; transient liquid phase sintering bonding; Ag flake; solder
• ISSN: 0361-5235; 1543-186X
• DOI: 10.1007/s11664-021-09102-4

In the 3D integrated circuit package industry, the remelting of solder joints during repeated stacking processes can cause electrical failure and low bonding strength. Transient liquid phase sintering (TLPS) bonding based on forming full intermetallic compounds (IMCs) in the solder joint to increase the remelting point has emerged as a potential solution to this issue. Here, pressureless TLPS Cu-Cu bonding was conducted with Sn-3.0Ag-0.5Cu solder powders and various Ag flake powder content (15 wt.%, 30 wt.%, 45 wt.%, and 60 wt.%). The TLPS paste was screen-printed and the bonding process was conducted at 255°C for 2 h in an air atmosphere without bonding pressure. Additionally, this study investigated the microstructural evolution and fracture modes of the TLPS joints after the shear tests were investigated. High-temperature storage tests were conducted at 300°C for 24 h, 48 h, and 96 h, and a shear test was then performed to evaluate bonding strength. A differential scanning calorimetry analysis of the TLPS paste was conducted to investigate the thermal behavior of the paste during the bonding process. No residual solder was found in TLPS joints with an Ag flake content above 45 wt.% The highest bonding strength in a TLPS joint with full IMC layers was 27.3 MPa, representing an approximately 9% decrease after 96 h of high-temperature storage test. TLPS bonding with an optimal composition was resistant to the remelting of solder joints due to the full IMC layers, i.e., it represents a reliable interconnection method for 3D stacking.