Accuracy Improvement of Stator Inductance Identification Method Based on Low-Frequency Current Injection for Three-Level NPC Inverter-Fed IM Drives in Locked-Rotor Standstill Condition

• Published in: Electronics (Basel) Vol. 10; no. 4; p. 488
• Main Authors: Khojakhan, Yerganat, Choo, Kyoung-Min, Yi, Junsin, Won, Chung-Yuen
• Format: Journal Article
• Language: English
• Published: 19.02.2021
• ISSN: 2079-9292; 2079-9292
• DOI: 10.3390/electronics10040488

In this paper, a stator inductance identification process is proposed. The process is based on a three-level neutral-point-clamped (NPC) inverter-fed induction motor (IM) drive with a standstill condition. Previously, a low-speed alternating current (AC) injection test for stator inductance identification was proposed to overcome practical problems in conventional identification methods for three-level NPC inverter-based IM drives. However, the low-speed AC injection test-based identification method has some problems if a heavy load or mechanical brake is connected, as these can forcibly bring the rotor to a standstill during parameter identification. Since this low-speed testing-based identification assumes the motor torque is considerably lower in low-speed operations, some inaccuracy is inevitable in this kind of standstill condition. In this paper, the proposed current injection speed generator is based on the previously studied low-speed test-based stator inductance identification method, but the proposed approach gives more accurate estimates under the aforementioned standstill conditions. The proposed method regulates the speed for sinusoidal low-frequency AC injection on the basis of the instantaneous reactive and air-gap active power ratio. This proposed stator inductance identification method is more accurate than conventional fixed low-frequency AC signal injection identification method for three-level NPC inverter-fed IM drive systems with a locked-rotor standstill condition. The proposed method’s accuracy and reliability were verified by simulation and experiment using an 18.5 kW induction motor.