Heat transfer of supercritical pressure water in helical tubes

• Published in: Frontiers in energy research Vol. 11
• Main Authors: Liu, Mengmeng, Zhang, Zhen, Yang, Xingtuan, Jiang, Shengyao
• Format: Journal Article
• Language: English
• Published: Frontiers Media S.A 15.02.2023
• Subjects: finite-thickness wall; helical tube; helix diameter; non-uniform heat transfer; supercritical-pressure water
• ISSN: 2296-598X; 2296-598X
• DOI: 10.3389/fenrg.2023.1129469

Subcritical steam generators in the current high-temperature gas-cooled reactor pebble-bed module in China can be replaced by supercritical steam generators to better coordinate the reactors and supercritical steam turbine unit to improve the thermal efficiency with no fluid phase change at supercritical pressures. The heat transfer of supercritical-pressure water flow in helical tubes with various helix diameters was simulated using the re-normalization group k – ε model to investigate the effects of finite-thickness walls, inlet mass flux, and helix diameter. The finite-thickness wall barely affected local heat transfer in the straight tube with inlet mass flux of 1,260 kg/(m 2 s) whereas the local heat transfer in the helical tube was very different with relative difference in q / q av between the inside and bottom, caused by the centrifugal force, is 36%. In helical tubes, the heat transfer coefficients in the inner bar were the lowest, with a low fluid velocity under the effect of the centrifugal force. The buoyancy and centrifugal force in the helical tubes caused non-uniformity in the wall temperature; however, when the fluid temperature increased below the pseudo-critical temperature, the temperature distributions showed an increasing trend. The non-uniformities in the wall temperature distributions decreased as the centrifugal force increased, and they were suppressed by the finite-thickness wall.