Material Extrusion 3D Printing of Micro-Porous Copper-Based Structure for Water Filters

This paper presents 3D-printed micro-porous structures made of a Cu/PLA composite by using material extrusion 3D printing technology. A metallic filament made of 80% copper and 20% polylactic acid (PLA) was used for the 3D printing of the porous samples. We varied printing parameters, aiming to obta...

Full description

Saved in:
Bibliographic Details
Published inMachines (Basel) Vol. 12; no. 7; p. 470
Main Authors Kotorčević, Nikola, Milenković, Strahinja, Živić, Fatima, Jordović, Branka, Adamović, Dragan, Todorović, Petar, Grujović, Nenad
Format Journal Article
LanguageEnglish
Published Basel MDPI AG 01.07.2024
Subjects
3-D printers
antibacterial filter
Copper
copper (Cu)
Cost analysis
Dimensional analysis
Extrusion
Filaments
Heat resistance
material extrusion 3D printing
Mechanical properties
metal additive manufacturing
nature-based material
Optimization techniques
Parameters
Pathogens
Plastic pollution
Polyethylene glycol
Polyethylene terephthalate
Polylactic acid
polylactic acid (PLA)
Polymers
Porosity
Porous materials
Software
Sustainable materials
Temperature
Three dimensional composites
Three dimensional flow
Three dimensional printing
Water flow
Water purification
United States > US
Online AccessGet full text

Cover

More Information
Summary:This paper presents 3D-printed micro-porous structures made of a Cu/PLA composite by using material extrusion 3D printing technology. A metallic filament made of 80% copper and 20% polylactic acid (PLA) was used for the 3D printing of the porous samples. We varied printing parameters, aiming to obtain a micro-range porosity that can serve as a water-filtering structure. The produced samples were analyzed from the aspects of dimensional accuracy, level of porosity, and capacity for water flow. Several samples were fabricated, and the water flow was exhibited for the samples with an approximate 100 µm size of the interconnected open porosity. The application of material extrusion 3D printing, as a cost-effective, widely available technology for producing micro-range porous structures, is still challenging, especially for interconnected predefined porosity with metal-based filaments. Our research showed that the optimization of 3D printing parameters can enable the fabrication of copper-based micro-porous structures, but further research is still needed.
ISSN:2075-1702
2075-1702
DOI:10.3390/machines12070470