EXPERIMENTAL STUDY ON POWER PARAMETERS OF “ROLLING - ECA-PRESSING” COMBINED PROCESS
Introduction. Power parameters of the “rolling − equalchannel angular pressing” (ECA) combined process are studied. The work objective is to determine forces of rolling and pressing in the deformation by the combined method. Materials and Methods. The die strength calculation and the experime...
Saved in:
Published in | Advanced engineering research (Rostov-na-Donu, Russia) Vol. 18; no. 3; pp. 289 - 299 |
---|---|
Main Authors | , , , |
Format | Journal Article |
Language | English Russian |
Published |
Don State Technical University
29.09.2018
|
Subjects | |
Online Access | Get full text |
Cover
Loading…
Summary: | Introduction. Power parameters of the “rolling − equalchannel angular pressing” (ECA) combined process are studied. The work objective is to determine forces of rolling and pressing in the deformation by the combined method.
Materials and Methods. The die strength calculation and the experiment on deformation of AISI 6063 aluminum samples were carried out. During the experiment, the force values were recorded using a strain-gauge station.
Research Results. The strength analysis results show that this die design is suitable for creating an experimental stand of the “rolling − ECA-pressing” combined process, since the calculated safety margin is sufficient to implement the pressing under extreme conditions. The rolling forces at all stages of the deformation exceed the corresponding pressing forces, which is a necessary condition for the combined process. Discussion and Conclusions. The obtained results can be used in the design of experimental stands that implement the investigated combined process. Herewith, the given strain-gauge method for studying strength characteristics is suitable for the case of calibrated rolls. |
---|---|
ISSN: | 1992-5980 1992-6006 2687-1653 |
DOI: | 10.23947/1992-5980-2018-18-3-289-299 |