Tensile behaviour of a novel grouted sleeve splice for high-strength rebars

• Published in: Structures (Oxford) Vol. 70; p. 107631
• Main Authors: Zhang, Xin, Yu, Shenlu, Feng, Shuaike, Huang, Wei, Li, Xiangyang
• Format: Journal Article
• Language: English
• Published: Elsevier Ltd 01.12.2024
• Subjects: Embedded length; Grouted sleeve splice; High-strength steel; Tensile strength; Uniaxial tensile loading; Grouted sleeve splice; High-strength steel; Uniaxial tensile loading; Tensile strength; Embedded length
• ISSN: 2352-0124; 2352-0124
• DOI: 10.1016/j.istruc.2024.107631

This study introduces a novel type of grouted sleeve fabricated from a standard low-alloy seamless steel pipe using cold-rolling techniques. The main goal is to achieve an effective connection between the high-strength steel (HSS) reinforcements in the joints of precast concrete structures. To investigate the structural performance of the developed splice under uniaxial tensile loading, 24 coupler specimens configured with 28 mm diameter HRB600 reinforcements were prepared. Two primary parameters, namely the embedded length of the spliced bar and number of inner concentric ribs rolled on the sleeve, were considered. By conducting direct pullout tests, the performance of the developed splices was thoroughly assessed based on the failure mode, bond stiffness, bond ductility, and strength. The test results demonstrated that increasing the bar embedded length and number of inner ribs enhances the initial bond stiffness and ductility of the splice. Increasing the quantity of inner ribs only in the inelastic region of the splice is effective for improving its tensile capacity. For grout splices with large-diameter HSS bars, an embedded length of 8db is recommended to guarantee bar fracture failure and satisfy the specification requirements. This length exceeds that of splices with normal-strength reinforcements. Finally, a formula was proposed to estimate the inelastic region length and tensile strength of the proposed splice.