Structures and high-velocity frictional properties of the Pingxi fault zone in the Longmenshan fault system, Sichuan, China, activated during the 2008 Wenchuan earthquake

• Published in: Tectonophysics Vol. 599; pp. 135 - 156
• Main Authors: Yao, Lu, Ma, Shengli, Shimamoto, Toshihiko, Togo, Tetsuhiro
• Format: Journal Article
• Language: English
• Published: Elsevier B.V 25.06.2013
• Subjects: Breccia; Direct current; Dynamics; Fault-zone structures; Faults; Fracture energy; Fracture mechanics; Friction; High-velocity friction; Longmenshan fault system; Pingxi fault; Seismic phenomena; Slip; Strengthening; Wenchuan earthquake; China, People's Rep; Fault-zone structures; High-velocity friction; Wenchuan earthquake; Longmenshan fault system; Pingxi fault; Fracture energy
• ISSN: 0040-1951; 1879-3266
• DOI: 10.1016/j.tecto.2013.04.011

This paper reports on the internal structures of the Pingxi fault zone near the northeastern end of the coseismic surface ruptures associated with the 2008 Wenchuan earthquake. The fault zone consists of a 50–80cm wide fault core and several-meter wide fault breccia zones. The fault core contains yellowish gouge (YG), gray-blackish gouge (GBG), black gouge (BG) and gray-blackish fault breccia. A coseismic slip during the Wenchuan earthquake occurred within GBG in a slip zone of 24±9mm in width. High-velocity friction experiments were conducted at normal stresses σn of 0.45–2.50MPa and slip rates v of 0.0014–2.09m/s. YG and GBG exhibit dramatic slip-weakening at constant high slip rates that can be described as an exponential decay from peak friction coefficient μp to steady-state friction coefficient μss over a slip-weakening distance Dc. Specific fracture energy EG for YG and GBG was 0.37–2.02MJ/m2 of the same order of magnitude as the fracture energy estimated for natural earthquakes. Empirical equations describing the changes in μp, μss and Dc in terms of σn and v indicate that EG decreases with increasing σn, so that higher-normal stress experiments will lead to EG lower than seismic values. Thus our experiments probably reproduced deeper seismic fault motion under dry conditions with respect to EG. Frictional behavior of BG is characterized by a sharp initial weakening, subsequent strengthening to the second peak friction, and slip weakening towards the steady-state friction. The initial weakening and strengthening seem to be caused by the formation of a very sharp slip zone (~5μm in width) and subsequent formation of a widely deformed zone. A comparison of our data with reported results for other outcrops indicates that the high-velocity frictional properties of the Longmenshan fault system may be quite uniform. The observed dramatic high-velocity weakening must have promoted dynamic rupture propagation during the Wenchuan earthquake. •Three types of Pingxi fault gouges all show dramatic weakening at seismic slip rates.•HV weakening of gouges must have promoted rupture propagation of Wenchuan earthquake.•Black gouge shows peculiar behavior with an initial sharp and large drop in friction.•Specific fracture energy from experiments agrees with seismically determined values.•High-velocity frictional properties may be uniform in Longmenshan fault system.