Assessing the Influence of Meteorological Parameters on the Performance of Polyurethane Foam-Based Passive Air Samplers

• Published in: Environmental science & technology Vol. 42; no. 2; pp. 550 - 555
• Main Authors: Klánová, Jana, Èupr, Pavel, Kohoutek, Jiří, Harner, Tom
• Format: Journal Article
• Language: English
• Published: Washington, DC American Chemical Society 15.01.2008
• Subjects: Air Pollutants - analysis; Applied sciences; Czech Republic; Environmental Measurements Methods; Environmental Monitoring - instrumentation; Environmental Monitoring - methods; Exact sciences and technology; Hydrocarbons, Chlorinated - analysis; Meteorology; Molecular weight; PCB; Plastic foams; Pollution; Polychlorinated biphenyls; Polycyclic Aromatic Hydrocarbons - analysis; Polyurethane; Polyurethanes; Temperature; Temperature effects; Wind; Atmospheric condition; Meteorological observation; Hydrocarbon; Pollutant behavior; Pesticides; Temperature effect; Polychlorobiphenyls; Wind effect; Polycyclic aromatic compound; Coarse particle; Persistent organic pollutant; Passive detection; Volume measurement; Foam; Correlation analysis; Organochlorine compounds; Chlorine Organic compounds; Sampler; Aerosols; Air pollution; Phase partition; Sampling; Organic compounds
• ISSN: 0013-936X; 1520-5851
• DOI: 10.1021/es072098o

Polyurethane foam (PUF) disk passive air samplers were evaluated under field conditions to assess the effect of temperature and wind speed on the sampling rate for polycyclic aromatic hydrocarbons (PAHs), polychlorinated biphenyls (PCBs), and organochlorine pesticides (OCPs). Passive samples integrated over 28-day periods were compared to high-volume air samples collected for 24 h, every 7 days. This provided a large data set of 42 passive sampling events and 168 high-volume samples over a 3-year period, starting in October 2003. Average PUF disk sampling rates for gas-phase chemicals was ∼7 m3 d−1 and comparable to previous reports. The high molecular weight PAHs, which are mainly particle-bound, experienced much lower sampling rates of ∼0.7 m3 d−1. This small rate was attributed to the ability of the sampling chamber to filter out coarse particles with only the fine/ultrafine fraction capable of penetration and collection on the PUF disk. Passive sampler-derived data were converted to equivalent air volumes (V EQ, m3) using the high-volume air measurement results. Correlations of V EQ against meteorological data collected on-site yielded different behavior for gas- and particle-associated compounds. For gas-phase chemicals, sampling rates varied by about a factor of 2 with temperature and wind speed. The higher sampling rates at colder temperatures were explained by the wind effect on sampling rates. Temperature and wind were strongly correlated with the greatest winds at colder temperatures. Mainly particle-phase compounds (namely, the high molecular weight PAHs) had more variable sampling rates. Sampling rates increased greatly at warmer temperatures as the high molecular weight PAH burden was shifted toward the gas phase and subject to higher gas-phase sampling rates. At colder temperatures, sampling rates were reduced as the partitioning of the high molecular weight PAHs was shifted toward the particle phase. The observed wind effect on sampling for the particle-phase compounds is believed to be tied to this strong temperature dependence on phase partitioning and hence sampling rate. For purposes of comparing passive sampler derived data for persistent organic pollutants, the factor of 2 variability observed for mainly gas-phase compounds is deemed to be acceptable in many instances for semiquantitative analysis. Depuration compounds may be used to improve accuracy and provide site-specific sampling rates, although this adds a level of complexity to the analysis. More research is needed to develop and test passive air samplers for particle-associated chemicals.