Numerical Simulation of Polymer Dispersion Systems for Polymer Injection on Offshore Platforms

• Published in: ACS omega Vol. 5; no. 32; pp. 20343 - 20352
• Main Authors: Wang, Zizhen, Li, Tianyang, Wang, Fangxiang, Guan, Lin, Zhang, Rui
• Format: Journal Article
• Language: English
• Published: American Chemical Society 18.08.2020
• ISSN: 2470-1343; 2470-1343
• DOI: 10.1021/acsomega.0c02307

Because of the limited space and high cost of offshore platforms, the dispersion and dissolution of the polymer are required to be of high efficiency, which is essential for polymer injection to enhance hydrocarbon recovery. The numerical simulation models of the water–powder mixing process by Venturi jetting and air-mixing were established. The multiphase flow fields in the water jet ejector, water–powder mixing head, and stirring tank were numerically simulated by FLUENT. Then, the distributions of velocity, volume fraction, pressure, and turbulent kinetic energy of each phase were obtained to evaluate the effects of polymer dispersion and the dissolution of the two mixing methods. According to the maximum velocity of the mixture at the Venturi jet, the optimized length of the throat is 25 mm in our models. The results of the air-mixing process show that a 120° angle of support rods has the best effect of water–powder mixing. The results of the present study show that compared with air-mixing, the combination of Venturi jet and the stirring tank can obtain a broader agitation range and more extensive effect on the flow field, which could uniformly disperse the polymer powder into water. This study has a guiding significance for the design of the onsite polymer injection process.