Photocatalytic Degradation of 2-Phenethyl-2-chloroethyl Sulfide in Liquid and Gas Phases

• Published in: Environmental science & technology Vol. 36; no. 23; pp. 5261 - 5269
• Main Authors: Vorontsov, Alexandre V, Panchenko, Alexander A, Savinov, Evgueni N, Lion, Claude, Smirniotis, Panagiotis G
• Format: Journal Article
• Language: English
• Published: United States American Chemical Society 01.12.2002
• Subjects: 2-phenethyl 2-chloroethyl sulfide; Air Pollutants; Air Pollution - prevention & control; Biological & chemical weapons; Catalysis; Chemical bonds; Chemical Warfare Agents - chemistry; Environmental impact; Gases; Mineralization; Mustard Gas - analogs & derivatives; Mustard Gas - chemistry; Photocatalysis; Photochemistry; Sulfur; Volatilization; Water Pollutants; Water pollution; Water treatment
• ISSN: 0013-936X; 1520-5851
• DOI: 10.1021/es0256109

This work explores the ability of photocatalysis to decontaminate water and air from chemical warfare agent mustard using its simulant 2-phenethyl 2-chloroethyl sulfide (PECES). PECES like mustard slowly dissolves in water with hydrolysis, forming 2-phenethyl 2-hydroxyethyl sulfide (PEHES). Irradiation of TiO2 suspension containing PECES with the unfiltered light of a mercury lamp (λ ≥ 254 nm) decomposed all PECES mostly via photolysis. Reaction under filtered light (λ > 300 nm) proceeds mainly photocatalytically and requires longer time. Sulfur from starting PECES is completely transformed into sulfuric acid at the end of the reaction. Detected volatile, nonvolatile, surface products, and the suggested scheme of degradation are reported. The main volatile products are styrene and benzaldehyde, nonvolatile − hydroxylated PEHES, surface − 2-phenethyl disulfide. Photolysis of PECES produced the same set of volatile products as photocatalysis. Photocatalytic degradation of gaseous PECES in air results in its mineralization but is accompanied by TiO2 deactivation. The highest rate of mineralization with minimum deactivation was observed at about room temperature and a water concentration of 27 500 ppm. No gaseous products except CO2 were detected. The main extracted surface product was styrene. It was concluded that PECES photocatalytic degradation proceeds mainly via C−S bond cleavage and further oxidation of the products. Hydrolysis of the C−S bond was detected only in gas-phase photocatalytic degradation. The quantum efficiency of gas-phase degradation (0.28%) was much higher than that of liquid-phase degradation (0.008%). The results demonstrate the ability of photocatalysis to decontaminate an aqueous and especially an air environment.