Suitable Cathode NMP Replacement for Efficient Sustainable Printed Li-Ion Batteries

• Published in: ACS applied energy materials Vol. 5; no. 4; pp. 4047 - 4058
• Main Authors: Sliz, Rafal, Valikangas, Juho, Silva Santos, Hellen, Vilmi, Pauliina, Rieppo, Lassi, Hu, Tao, Lassi, Ulla, Fabritius, Tapio
• Format: Journal Article
• Language: English
• Published: United States American Chemical Society 25.04.2022
• Subjects: NMP; NMC523; NMC; solvent; NMC88; DMF; screen printing; printed batteries
• ISSN: 2574-0962; 2574-0962
• DOI: 10.1021/acsaem.1c02923

N-methyl-2-pyrrolidone (NMP) is the most common solvent for manufacturing cathode electrodes in the battery industry; however, it is becoming restricted in several countries due to its negative environmental impact. Taking into account that ∼99% of the solvent used during electrode fabrication is recovered, dimethylformamide (DMF) is a considerable candidate to replace NMP. The lower boiling point and higher ignition temperature of DMF lead to a significant reduction in the energy consumption needed for drying the electrodes and improve the safety of the production process. Additionally, the lower surface tension and viscosity of DMF enable improved current collector wetting and higher concentrations of the solid material in the cathode slurry. To verify the suitability of DMF as a replacement for NMP, we utilized screen printing, a fabrication method that provides roll-to-roll compatibility while allowing controlled deposition and creation of sophisticated patterns. The battery systems utilized NMC (LiNi x Mn y Co z O2) chemistry in two configurations: NMC523 and NMC88. The first, well-established NCM523, was used as a reference, while NMC88 was used to demonstrate the potential of the proposed method with high-capacity materials. The cathodes were used to create coin and pouch cell batteries that were cycled 1000 times. The achieved results indicate that DMF can successfully replace NMP in the NMC cathode fabrication process without compromising battery performance. Specifically, both the NMP blade-coated and DMF screen-printed batteries retained 87 and 90% of their capacity after 1000 (1C/1C) cycles for NMC523 and NMC88, respectively. The modeling results of the drying process indicate that utilizing a low-boiling-point solvent (DMF) instead of NMP can reduce the drying energy consumption fourfold, resulting in a more environmentally friendly battery production process.