Condensed Phase Deactivation of Solid Brønsted Acids in the Dehydration of Fructose to Hydroxymethylfurfural
Catalyst deactivation resulting from the hydrothermal leaching of sulfonic acid residues and the deposition of carbonaceous residues was studied using condensed phase flow reactor experiments along with state-of-the-art solid-state NMR. Several commercially available sulfonic acid-containing heterog...
Saved in:
Published in | ACS catalysis Vol. 9; no. 12; pp. 11568 - 11578 |
---|---|
Main Authors | , , , , , , , , , |
Format | Journal Article |
Language | English |
Published |
United States
American Chemical Society
06.12.2019
American Chemical Society (ACS) |
Subjects | |
Online Access | Get full text |
Cover
Loading…
Summary: | Catalyst deactivation resulting from the hydrothermal leaching of sulfonic acid residues and the deposition of carbonaceous residues was studied using condensed phase flow reactor experiments along with state-of-the-art solid-state NMR. Several commercially available sulfonic acid-containing heterogeneous Brønsted acids were compared by measuring the rates of sulfonic acid breakdown at hydrothermal flow conditions of 160 °C. Amberlyst 45 was found to show higher hydrothermal stability when compared to both Nafion and Amberlyst 15, with <10% loss in acidity after 48 h. The dehydration reaction of fructose to hydroxymethylfurfural (HMF) was used as a model system to compare deactivation rates from carbon deposition (fouling) to those from sulfur leaching, and deactivation from fouling was shown to be dramatically faster than that from sulfonic acid leaching alone. Fouling rates were then investigated in greater detail by comparing the influence of several factors including reactant, solvent, residence time, and feed concentration. The only successful approach to minimize fouling was the use of a polar aprotic solvent [dimethyl sulfoxide (DMSO)] with dilute (50 mM) reactant streams. In aqueous systems, operating the reactor in a regime with low conversion conditions (short residence times) does not significantly improve the longevity of the catalyst. Spent catalysts were characterized using 13C solid-state NMR spectroscopy enhanced by dynamic nuclear polarization. Additionally, in situ 1H and 13C high-resolution magic angle spinning (HR-MAS) solid-state NMR spectroscopies were used to investigate the solvent influence at the catalyst interface. The HR-MAS NMR studies showed that in polar aprotic solvents, the increased acidity leads to greater selectivity toward HMF; more importantly, that the dehydration products do not readily adhere to the surface in DMSO, in contrast to their behavior in water. The results demonstrate that more active and longer-lived acid catalysts could be obtained by tuning the solvent and surface polarity to allow for efficient desorption of products, thereby reducing the catalyst deactivation that occurs due to fouling. |
---|---|
Bibliography: | AC02- 07CH11358; EEC-0813570 USDOE Office of Science (SC), Basic Energy Sciences (BES) IS-J-10101 |
ISSN: | 2155-5435 2155-5435 |
DOI: | 10.1021/acscatal.9b03455 |