A quantitative and visual examination of sealed restorative specimens following exposure to artificial aging

• Published in: General dentistry Vol. 68; no. 3; p. 51
• Main Authors: Turpin, David R, Owens, Barry M, Phebus, Jeffrey G, Morrow, Brian R, Hill, Anne E, Hamilton, Bruce N, Clark, Shawn R
• Format: Journal Article
• Language: English
• Published: United States 01.05.2020
• Subjects: surface sealant; surface roughness; thermocycling
• ISSN: 0363-6771

Low-viscosity polymer resins, or surface sealants (SSs), have been utilized as a means of finalizing the polishing step following the placement of composite resin restorations. The aim of this study was to measure the surface roughness (R ) of composite resins treated with different SSs before and after exposure to an accelerated artificial aging protocol. The study included 5 experimental groups of composite resin discs (TPH Spectra ST) treated with different SSs (PermaSeal, Embrace WetBond Seal-n-Shine, OptiGuard, BisCover LV, and DuraFinish) and a control group consisting of untreated discs (n = 6 per group). The discs were prepared by inserting composite resin in 10 × 1-mm rings, covering the ring and material with a transparent strip, compressing the assembly between glass slides, and polymerizing through the slides on each side for 40 seconds with an LED curing light. Each disc except for the control specimens received a coating of the selected SS followed by application of a transparent matrix strip and then light polymerization for 20 seconds using an LED light source. Surface roughness measurements were obtained with a digital contact profilometer at baseline (immediately after polymerization) and following exposure to a thermocycling regimen to simulate aging. The data were analyzed using 2-way analysis of variance and post hoc Student-Newman-Keuls test with significance set at P < 0.05. There were no statistically significant differences among the groups at baseline. There were no statistically significant differences between the baseline and post-thermocycling R measurements except among the DuraFinish specimens, which were significantly rougher than all other groups after accelerated artificial aging. The use of SSs for the initial insertion and possibly for the long-term maintenance of composite resins could be minimally beneficial for restoration maintenance if a transparent covering medium is utilized during polymerization. However, due to the effects caused by formation of an oxygen-inhibited layer of unpolymerized monomers if a covering medium is not used, the results suggest the benefits do not offset the costs considering both gloss and R surface-testing parameters.