A prediction method for abrasion loss rate of some Egyptian carbonate rocks due to cyclic salt crystallization weathering using physico-mechanical deterioration: insights from laboratory investigations

• Published in: Acta geodaetica et geophysica Vol. 58; no. 1; pp. 53 - 70
• Main Authors: Abdelhamid, Marzouk Mohamed Aly, Mousa, B. G.
• Format: Journal Article
• Language: English
• Published: Cham Springer International Publishing 01.03.2023; Springer Nature B.V
• Subjects: Abrasion; Carbonate rocks; Carbonates; Compression; Compressive strength; Crystallization; Cycles; Degradation; Earth and Environmental Science; Earth Sciences; Environmental conditions; Geophysics/Geodesy; Limestone; Load distribution; Mathematical analysis; Mechanical properties; Original Study; Porosity; Salts; Sediment samples; Weathering; Point load index; Uniaxial compression strength; Carbonate rocks; Long term degradation; Salt crystallization weathering; Abrasion loss
• ISSN: 2213-5812; 2213-5820
• DOI: 10.1007/s40328-023-00401-2

Salt crystallization is the most important weathering processes that causes problems for rocks used as building stones. Therefore, assessment of the physico-mechanical properties of stones against cyclic salt crystallization is a critical issue for rock engineering applications in salty environmental conditions especially prone to abrasion. This research aims at investigating the relationship between the degradation of various physico-mechanical properties including apparent porosity, point load index, unconfined compression strength and abrasion loss rate for rocks during salt weathering process. For showing rock weathering in the salt crystallization process, five kinds of carbonate rocks were sampled from different areas of Egypt and subject to cyclic salt crystallization, up to twenty cycles. The variation rates of their physico-mechanical characteristics and abrasion loss values were calculated after each five cycles of salt weathering. The results showed that the studied rocks are suitable for use as building and decorative stones in areas prone to crystallization of salts, but attention must be paid to rocks with high porosity and low strength characteristics such as El-Minia limestone specimens. It was also found that there are strong linear correlations between the physico-mechanical degradation parameters and the abrasion loss rate of the studied rock samples at the end of the twentieth cycle of salt weathering. These relationships may be used to estimate the abrasion loss rate of the studied rock types against the cyclic salt weathering conditions and hence to make a rapid evaluation of the stone durability.